# Running Redis and Using redis-cli — Redis Pub/Sub & Streams

Source: https://www.skillbyai.com/en/redis-streams/f-setup

> Start Redis locally and experiment with messaging commands.

## A playground in one command

The quickest way to experiment is the official container image: `docker run -p 6379:6379 redis:8` (or `valkey/valkey` for **Valkey**, the Linux Foundation fork created in 2024, which supports the same Pub/Sub and Streams commands). Connect with **`redis-cli`**; open two terminals to watch a publisher and a subscriber interact. In production you would use a managed service (Amazon ElastiCache or MemoryDB, Azure Managed Redis, Google Memorystore, Redis Cloud) or a self-managed deployment with replication. Clients talk the **RESP** protocol; **RESP3** (available since Redis 6) lets a single connection receive Pub/Sub pushes while still running other commands, whereas with RESP2 a connection in subscribed mode can only issue subscription commands, `PING`, `RESET` and `QUIT`. Mind the licensing landscape: Redis changed licences in 2024 and added an AGPLv3 option with Redis 8, while Valkey remains BSD-licensed; both are widely used.

## Two terminals, one channel

Run the subscriber first, then publish from the second terminal.

```bash
docker run -d --name redis -p 6379:6379 redis:8

# terminal 1
redis-cli SUBSCRIBE orders.updates

# terminal 2
redis-cli PUBLISH orders.updates '{"orderId":"o-1001","status":"shipped"}'
# PUBLISH replies with how many subscribers received the message

# inspect active channels and subscriber counts
redis-cli PUBSUB CHANNELS 'orders.*'
redis-cli PUBSUB NUMSUB orders.updates
```

## A walkie-talkie channel

Pub/Sub is a walkie-talkie channel: everyone tuned in hears the message at that moment. If your set was switched off, nobody repeats it for you.

**Quiz:** With the RESP2 protocol, what can a connection do after it issues SUBSCRIBE?

- [ ] Run any Redis command as usual
- [ ] Only PUBLISH
- [ ] Nothing until it disconnects
- [x] Only subscription-related commands plus PING, RESET and QUIT

*Answer:* Only subscription-related commands plus PING, RESET and QUIT. In RESP2 a subscribed connection is limited to subscription commands; RESP3 lifts this restriction.